<img src="http://www.bearing.com.cn/RecommendedCompany/1-Ruland-oldham-coupling-with-actuator.jpg"> Ruland Manufacturing Co., Inc. presents Oldham couplings for actuator driven systems. The Oldham couplings are zero-backlash, have a balanced design, and high parallel misalignment capabilities, making them an ideal fit for screw driven actuator applications. The three-piece design allows designers to easily couple an actuator and motor that have keyed or keyless shafts with an inch or metric bores. Oldham couplings can accommodate all forms of misalignment and are best suited for applications with high parallel misalignment. The only resistance on the disk is frictional, limiting bearing loads and protecting delicate components. Oldham couplings have a balanced design for reduced vibration at high speeds. This is especially useful for motor-actuator driven applications that are positioning expensive items that are sensitive to minor vibrations. Oldham couplings are electrically isolating due to the non-conductive nature of the centre disk preventing electrical currents from being passed to sensitive equipment. <img src="http://www.bearing.com.cn/RecommendedCompany/2-Ruland-oldham-couplings.jpg"> Oldham couplings are made from two black anodised aluminium hubs that mate to a centre disk. This allows for a highly customizable coupling where clamp and set screw hubs can combine inch, metric, keyed, and keyless bores. Ruland uses a proprietary hub machining process that leaves a smoother surface for interaction between the hub and disk, resulting in long life and reduced downtime. The disk is available in acetal for zero-backlash and high torque capacity, PEEK for high temperature and low outgassing, and nylon for dampening and noise reduction. In the event of wear or failure, the disk can be replaced, restoring the original performance characteristics to the coupling. Oldham couplings also act as a mechanical fuse during torque overload situations, with the disk cleanly breaking and stopping power transmission. Ruland Oldham couplings are available in bore sizes from 1/8 into 1-1/8 in and 3 mm to 30 mm. Stainless steel hubs are available upon request for a clean room, vacuum, or highly corrosive environments. Disks can be manufactured with a centre hole to allow further shaft penetration or slots for retention hardware to attach the disk to a hub so it can stay in place during disassembly. Company information: Ruland Manufacturing Co., Inc. was established in 1937 as a manufacturer of precision components. Ruland’s focus for the past 40 years has been on high performing shaft collars and couplings. All Ruland products are made in its Marlborough Massachusetts factory. The complete line of products includes shaft collars and rigid couplings, and a full line of motion control couplings: beam couplings, bellows couplings, Oldham couplings, miniature disc couplings and zero backlash jaw couplings.